Yamaha MCR E810 Owner's Manual - Page 15

INTRODUCTION ■ Installing the batteries in the remote control Press Controls and Functions ■ Using the remote control Use the remote control within 6 m (20 feet) of the component you want to control and point it toward its remote control sensor (see pages 3 and 6). NATURAL SOUND STEREO RECEIVER RX-E810 PURE DIRECT Within 6 m (20 feet) TIMER STANDBY/ON PHONES DISPLAY MEMORY AUTO/MAN'L PRESET/BAND PRESET/TUNING BASS TIME ADJ TIMER TREBLE HOUR BALANCE MIN INPUT L R VOLUME MIN MAX 30˚ 30˚ 1 Press the mark on the battery cover and open the cover. 2 Insert the two supplied batteries (AA, R06, UM-3) into the battery compartment. Make sure you insert the batteries according to the polarity markings (+ and -). 3 Close the battery cover. Notes • Do not use an old battery together with new one. • Do not use different types of batteries (for example, alkaline and manganese) together. Each type of battery has its own characteristics even if they are similar in shape. • If the batteries run out, immediately remove them from the remote control to prevent an explosion or acid leak. • Dispose of the batteries according to the regional regulations. • If a battery starts leaking, dispose of it immediately. Be careful not to let leaking battery acid come into contact with your skin or clothing. Before inserting new batteries, wipe the compartment clean. • Replace the batteries within two minutes to preserve the memory in the remote control. Notes • Be careful not to spill liquid on the remote control. • Be careful not to drop the remote control. • Do not leave the remote control in the following places: - hot or humid places, such as near a heater or in a bathroom - extremely cold places - dusty places English 11 En