Yamaha MCR E810 Owner's Manual - Page 26

Basic Receiver Operations Basic Receiver Operations Follow the procedure below to select an input source and adjust the sound settings on the receiver. PHONES BALANCE PURE DIRECT NATURAL SOUND STEREO RECEIVER RX-E810 PURE DIRECT TIMER STANDBY/ON PHONES DISPLAY MEMORY AUTO/MAN'L PRESET/BAND PRESET/TUNING BASS TIME ADJ TIMER TREBLE HOUR BALANCE MIN INPUT L R VOLUME MIN MAX BASS TREBLE STANDBY/ON () STANDBY/ON POWER TV 1 5 AE 9 SET UP 2 3 4 6 7 8 ENTERSCAN 0 DIMMA EER TOP MENU /RETURN TV VOL DISPLAY VOLUME SLEEP DVD/CD TUNER BAND TAPE/MD AUX/TV DOCK SUBTITLE ANGLE ZOOM AUDIO VOLUME +/- Input selection keys 1 Press STANDBY/ON to turn on the receiver. If the DVD player is connected to the receiver with the system control cable, the DVD player turns on automatically. The front panel display of each component lights up. y This system has the auto-standby function (see page 45) which automatically set to the system to the standby mode if you do not operate the system for 30 minutes while the receiver is set to the DVD/CD input mode. 3 Start playback on the selected source component or select a broadcast station. For information on the disc playback, see page 25, and for information on tuning, see page 37. 4 Press VOLUME +/- to adjust the volume to the desired output level. 5 Rotate BASS, TREBLE, or BALANCE on the front panel of the receiver to adjust the following settings. BASS: Adjusts the low frequency response. TREBLE: Adjusts the high frequency response. BALANCE: Adjusts the volume level of each left and right speaker channel. ■ Pure Direct mode The Pure Direct mode shuts down the tone control circuitry, allowing you to enjoy pure high-fidelity sounds from analog sources. Press PURE DIRECT on the front panel of the receiver to turn on the Pure Direct mode. PURE DIRECT lights up, and the front panel display automatically dims. Notes • While the Pure Direct mode is turned on, neither BASS, TREBLE, nor BALANCE are available. • If you carry out any operation while the Pure Direct mode is turned on, the front panel display lights up briefly to acknowledge the command and dims again. To turn off the Pure Direct mode Press PURE DIRECT again so that PURE DIRECT turns off and the front panel display lights up. ■ To use headphones Connect the headphones to the PHONES jack. You can listen to the sound to be output from the speakers through the headphones. 2 Press one of the input selection keys to select the desired input source. 22 En