Yamaha MCR E810 Owner's Manual - Page 66

Troubleshooting Problem Cause Remedy Disc playback does not start. You may use a CD-R/RW, DVD+R/RW Finalize the CD-R/RW, DVD+R/RW or DVD-R/RW. or DVD-R/RW that is not finalized. The disc label may not be facing up. Check that the disc label is facing up. The disc may be defective. Try to play back another disc. If the same problem does not happen, the disc you want to play back is defective. JPEG or MP3/ WMA disc may not contain sufficient picture files or music tracks to be played back. Check that your JPEG or MP3/ WMA disc contains at least 10 JPEG picture files or 5 MP3/WMA music files. For MP3/WMA files, the sampling rate and bit rate may not be compatible. For JPEG files, the resolution may not be compatible. For MP3/WMA files, check that the sampling rate and bit rate are compatible. For JPEG files, check that the resolution is compatible. The region code of the disc may not be supported with the DVD player. Check the region code. Picture freezes momentarily during playback. The disc may be dirty. Check the disc for fingerprints/scratches and clean it with a soft cloth wiping from center to edge. The DVD player does not read CDs and DVDs. The disc lens may be dirty. Use a lens cleaner to clean the lens. Unable to turn on or The component video signal output setting Set "COMPONENT" of the DVD player to match the off a progressive scan may not match the video connection. connection method. No sound during DivX The audio code may not be supported with movie playback the DVD player. See page - - - - 63 63 64 64 54 Remote control Problem The remote control does not work nor function properly. Cause Wrong distance or angle. Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. The batteries are weak. The remote control code is not correctly set. Even if the remote control code is correctly set, there are some models that do not respond to the remote control. Remedy The remote control functions within a maximum range of 6 m (20 ft) and no more than 30 degrees offaxis from the front panel. Reposition this system. Replace all batteries. Set the remote control code correctly using "LIST OF REMOTE CONTROL CODES" at the end of this manual. Try setting another code for the same manufacturer using "LIST OF REMOTE CONTROL CODES" at the end of this manual. See page 11 - 11 48 48 62 En