Yamaha MCR E810 Owner's Manual - Page 16

CONNECTING THE SYSTEM Connecting the System Make sure you read the following procedure and notes carefully before connecting the system. For information on the speakers (NX-E800), refer to the owner's manual supplied with it. Note Do not connect the power cable of the receiver, DVD player, or other components to the wall outlet until all cable connections are completed. Right speaker (NX-E800) 3 Left speaker (NX-E800) 3 DOCK DVD/CD ANTENNA 75 UNBAL. FM GND IN TAPE/MD OUT AM SPEAKERS 6 MIN / SPEAKER R L SUBWOOFER OUT TO DVD-E810 AUX R L 1 MAINS AV MAINS AC OUTLETS SWITCHED 100W MAX. TOTAL 2 Receiver (RX-E810) (Europe model) VIDEO OUT COMPONENT PR Y DIGITAL OUT AUDIO OUT L COAXIAL OPTICAL TO RX-E810 S VIDEO VIDEO PB R DVD player (DVD-E810) 1 Connect the DVD/CD (L/R) jacks of the receiver to the AUDIO OUT (L/R) jacks of the DVD player using the supplied audio pin cable. 2 Connect the system connector (TO DVD-E810) jack of the receiver to the system connector (TO RX-E810) jack of the DVD player using the supplied system control cable. 3 Connect the speaker terminals (L) of the receiver to the speaker terminals of the left speaker and the speaker terminals (R) of the receiver to the speaker terminals of the right speaker using the speaker cables supplied with the speaker set (NX-E800). See page 13 for details. y • The system control connection is used to synchronize the specific operations between the receiver and the DVD player. • If you want to connect an amplifier with a digital input instead of the RX-E810, use the DIGITAL OUT (COAXIAL or OPTICAL) jacks of the DVD player and configure the "DIGITAL OUTPUT" setting in the setup menu (see page 52). 12 En