Yamaha RX-V461 Owner's Manual - Page 23
Connecting the FM and AM antennas, Connecting the power cable, Turning on and off the power - specifications
UPC - 027108927671
View all Yamaha RX-V461 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
PREPARATION Connections Connecting the FM and AM antennas Both FM and AM indoor antennas are supplied with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals. Notes • The AM loop antenna should be placed away from this unit. • A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center about outdoor antennas. • The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit. Outdoor AM antenna Use a 5 to 10 m (16 to 32 ft) of vinyl-covered wire extended outdoors from a window. AM loop Indoor FM antenna antenna (supplied) (supplied) ANTENNA AM GND FM 75 UNBAL. IN MD/ (PLAY) CD-R Connecting the power cable Once all connections are complete, plug the power cable into the AC wall outlet. (U.S.A. model) AC OUTLETS Power cable ■ AC OUTLET(S) (SWITCHED) Australia model 1 outlet Korea model None Other models 2 outlets Use these outlet(s) to supply power to any connected components. Connect the power cable of your other components to these outlet(s). Power to these outlet(s) is supplied when this unit is turned on. However, power to these outlet(s) is cut off when this unit is set to the standby mode. For information on the maximum power or the total power consumption of the components that can be connected to these outlet(s), see "Specifications" on page 74. Turning on and off the power ■ Turning on this unit Ground For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. Press 1STANDBY/ON (or HPOWER) to turn on this unit. y When you turn on this unit, there will be a 4 to 5-second delay before this unit can reproduce sound. ■ Set this unit to the standby mode Press 1STANDBY/ON (or GSTANDBY) to set this unit to the standby mode. In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control. English 19 En