Yamaha RX-V461 Owner's Manual - Page 37
Selecting the night listening mode, Displaying signal information
UPC - 027108927671
View all Yamaha RX-V461 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
BASIC OPERATION p ■ Selecting the night listening mode The night listening modes are designed to improve listenability at lower volumes or at night. Playback ■ Displaying signal information You can display the format, sampling frequency, channel, bit rate and flag data of the current input signal. 1 Set the operation mode selector (K) to AMP and then press RNIGHT repeatedly to select "NIGHT:CINEMA" or "NIGHT:MUSIC". Choices: NIGHT:CINEMA, NIGHT:MUSIC, OFF • Select "NIGHT:CINEMA" to reduce the dynamic range of film soundtracks and make dialog easier to hear at lower volumes. • Select "NIGHT:MUSIC" to preserve ease-oflistening for all sounds. • Select "OFF" if you do not want to use this feature. y When a night listening mode is selected, the NIGHT indicator lights up in the front panel display. 2 Press Dl / h to adjust the effect level while "NIGHT:CINEMA" or "NIGHT:MUSIC" is displayed in the front panel display. Choices: MIN, MID, MAX • Select "MIN" for minimum compression. • Select "MID" for standard compression. • Select "MAX" for maximum compression. y "NIGHT:CINEMA" and "NIGHT:MUSIC" adjustments are stored independently. Notes • You cannot use the night listening modes in the following cases: - when the DIRECT STEREO mode (see page 32) is selected. - when the component connected to the MULTI CH INPUT jacks is selected as the input source. - when headphones are connected to the PHONES jack. • The night listening modes may vary in effectiveness depending on the input source and surround sound settings you use. 1 Set the operation mode selector (K) to AMP and then press NSET MENU on the remote control. The top "SET MENU" display appears in the OSD. SET MENU TOP MENU . ;AUTO SETUP ;MANUAL SETUP .A;SIGNAL INFO [ ]/[ ]:Up/Down [ENTER]:Enter p 2 Press Dn repeatedly to select "SIGNAL INFO" and then press DENTER. The following information about the input source appears in the OSD. ;SIGNAL INFO . FORMAT DolbyD SAMPLING 48kHz CHANNEL 3/2/0.1 BITRATE 384kbps FLAG None [RETURN]:Exit Display Description FORMAT Signal format. SAMPLING The number of samples per second taken from a continuous signal to make a discrete signal. CHANNEL The number of source channels in the input signal (front/surround/LFE). BITRATE The number of bits passing a given point per second. FLAG Flag data encoded in DTS, Dolby Digital, or PCM signals that cue this unit to automatically switch decoders. y The information indicated by the cursor is also displayed in the front panel display. 3 Press NSET MENU again to exit from "SET MENU". English 33 En