Yamaha RX-V461 Owner's Manual - Page 34

PLAYBACK Playback Caution Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS. y Before performing operations, set the operation mode selector (K) to AMP. Basic operations 1 Turn on the video monitor connected to this unit. 4 Rotate 8VOLUME (or press JVOLUME +/ -) to adjust the volume to the desired output level. 5 Press APROGRAM l / h repeatedly (or press one of the sound field program selector buttons (P) repeatedly) to select the desired sound field program. The name of the selected sound field program appears in the front panel display. See page 35 for details about sound field programs. Movie Dramatic Currently selected surround field program 2 Press DINPUT l / h repeatedly (or press one of the input selector buttons (A)) to select the desired input source. The name of the currently selected input source appears in the front panel display for a few seconds. Available input source DVR V-AUX DTV/CBL DVD MD/CD-R TUNER CD XM INPUT: DVD Currently selected input source y The corresponding input selector button on the remote control for the currently selected input source lights up for approximately 5 seconds after you press any buttons on the remote control, showing which source component is currently being operated. 3 Start playback on the selected component or select a broadcast station. • Refer to the operating instructions for the source component. • See page 38 for details about FM/AM tuning instructions. • See page 41 for details about XM Satellite Radio tuning instructions. Notes • Choose a sound field program based on your listening preference, not merely on the name of the program. • When you select an input source, this unit automatically selects the last sound field program used with the corresponding input source. • Sound field programs cannot be selected when the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 31). • When PCM signals with a sampling frequency higher than 48 kHz are input, this unit is automatically set to the "STRAIGHT" mode (see page 36). • To display information about the currently selected input source in the OSD, see page 33 for details. ■ A quick guide to contents When you want to... Enjoy pure hi-fi stereo sound Adjust the tonal quality of the front speakers Adjust the parameters of sound field programs Enjoy the sources with a wide dynamic range at night Use headphones Select a decoder to play back sources with Automatically set this unit to the standby mode See page 32 32 37 33 34 36 34 30 En