Yamaha RX-V595aRDS Owner's Manual - Page 17
Output Terminals For Driving A Speaker With An External Amplifier, How To Connect
View all Yamaha RX-V595aRDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
English How to connect Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and - markings are observed. If these wires are reversed, the sound will be unnatural and lack bass. Caution Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage the unit and/or speakers. Connecting to the MAIN SPEAKERS terminals Connecting to the REAR and CENTER SPEAKERS terminals Red: positive (+) Black: negative (-) 2 1 3 1 Unscrew the knob. 2 Remove approx. 5 mm (1/4") of insulation from each of the speaker wires and insert one bare wire into each terminal. 3 Tighten the knob to secure the wire. Red: positive (+) Black: negative (-) 3 2 1 Press the tab. 2 Remove approx. 5 mm 1 (1/4") of insulation from each of the speaker wires and insert one bare wire into each terminal. 3 Release the tab to secure the wire. OUTPUT TERMINALS (FOR DRIVING A SPEAKER WITH AN EXTERNAL AMPLIFIER) The speaker connections described on page 16 are fine for most applications. If for some reason, however, you wish to drive main, center and/or rear speakers with your existing amplifier, etc., the following terminals are available for connecting an external amplifier(s) to this unit. 17