Yamaha RX-V595aRDS Owner's Manual - Page 52
The DVD/LD, TV or DBS source, The DVD/LD player, TV or DBS tuner is
View all Yamaha RX-V595aRDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Amplifier SYMPTOM No sound from the effect speakers. No sound from the rear speakers. No sound from the center speaker. The sound field cannot be recorded. The DVD/LD, TV or DBS source cannot be recorded on a tape deck, MD recorder or VCR connected to this unit. FM stereo reception is noisy. There is distortion and clear reception cannot be obtained even with a good FM antenna. The desired station cannot be tuned in with the automatic tuning method. Previously preset stations can no longer be tuned in. The desired station cannot be tuned in with the automatic tuning method. There are continuous crackling and hissing noises. There are buzzing and whining noises (especially in the evening). CAUSE The sound effect setting is off. A Dolby Surround or DTS decoding program is being used with material not encoded with Dolby Surround or DTS. The sound output level of the rear speakers is set to minimum. A monaural sound source is being played in the DOLBY PRO LOGIC or DOLBY PRO LOGIC ENHANCED program. The sound output level of the center speaker is set to minimum. The function "CNTR" in the SET MENU is set to the NONE position. Incorrect sound field program selection. The input signals of the source encoded with Dolby Digital or DTS do not have center channel signals. It is not possible to record the sound field on a tape deck or MD recorder connected to the unit's REC OUT terminals. The DVD/LD player, TV or DBS tuner is connected to the unit by only the digital terminals. The characteristics of FM stereo broadcasts may cause this problem when the transmitter is too far away or the antenna input is poor. There is multipath interference. The station is too weak. The unit has been unplugged for a long period. The signal is weak or the antenna connections are loose. Noise will result from lightning, fluorescent lamps, motors, thermostats and other electrical equipment. A television set is being used nearby. REMEDY Press EFFECT on the front panel or EFCT ON/OFF on the remote control to turn it on. Use a different sound field program. Raise the sound output level of the rear speakers. Select another sound field program suitable for the monaural sound source. Raise the sound output level of the center speaker. Select the LARGE or SMALL position. Select the appropriate program. Refer to the instructions for the source being currently played. Make additional connections between the analog terminals. Check the antenna connections. Try using a high-quality directional FM antenna. Set TUNING MODE to the manual tuning mode. Adjust the antenna position to eliminate multipath interference. Use the manual tuning method. Use a high-quality directional FM antenna. Repeat the presetting procedure. Tighten the AM loop antenna connections and rotate it for best reception. Use the manual tuning method. Use an outdoor antenna and a ground wire. This will help somewhat, but it is difficult to eliminate all noise. Relocate this unit away from the TV. FM AM 52