Yamaha RXV465 Owner's Manual - Page 54

Remote control, iPod, Connect error, Unknown iPod, iPod Connected, Disconnected - replacement remote

Get Yamaha RXV465 - RX AV Receiver PDF manuals and user guides
UPC - 027108933214
View all Yamaha RXV465 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 54 highlights

Troubleshooting Remote control Problem The remote control does not work or function properly. iPod Cause Remedy Wrong distance or angle. Direct sunlight or lighting (from an inverter type of fluorescent lamp, strobe light, etc.) is striking the remote control sensor of this unit. The batteries are weak. The remote control ID of the remote control and this unit do not match. The remote control code is not correctly set. Even if the remote control code is correctly set, there are some models that do not respond to the remote control. The remote control will function within a maximum range of 6 m (20 ft) and no more than 30 degrees offaxis from the front panel. Adjust the lighting angle or reposition this unit. Replace all batteries. Match the remote control ID of this unit and the remote control. Set the remote control code correctly using "List of remote control codes" at the end of this manual. Try setting another code of the same manufacturer using "List of remote control codes" at the end of this manual. If this unit does not work when you press nCursor, do the following. When the key does not work during DVD disc menu operation: press the gInput selection keys on the remote control again. When the key does not work during OPTION menu/ SETUP menu operation: press the key applicable for the current menu operation again. See page 9 - 9 45 44 44 - Note • In case of a transmission error without a status message appearing on the front panel display, check the connection of your iPod (see page 16). Problem Cause Remedy See page Loading... This unit is in the middle of recognizing the connection with your iPod. This unit is in the middle of acquiring song lists from your iPod. Connect error There is a problem with the signal path Turn off this unit and reconnect the Yamaha iPod 16 from your iPod to this unit. universal dock to the DOCK terminal of this unit. Remove your iPod in the Yamaha iPod universal dock 16 and then place it back in the dock. Unknown iPod The iPod being used is not supported by This unit supports iPod Touch, iPod (Click Wheel), - this unit. iPod nano and iPod mini. iPod Connected Your iPod is properly placed in the Yamaha iPod universal dock. Disconnected Your iPod is removed from the Yamaha Place your iPod in the Yamaha iPod universal dock. 16 iPod universal dock. 50 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
50
En
Troubleshooting
Note
•
In case of a transmission error without a status message appearing on the front panel display, check the connection of your iPod (see page 16).
Remote control
Problem
Cause
Remedy
See
page
The remote control
does not work or
function properly.
Wrong distance or angle.
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees
offaxis from the front panel.
9
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, strobe
light, etc.) is striking the remote control
sensor of this unit.
Adjust the lighting angle or reposition this unit.
—
The batteries are weak.
Replace all batteries.
9
The remote control ID of the remote
control and this unit do not match.
Match the remote control ID of this unit and the
remote control.
45
The remote control code is not correctly
set.
Set the remote control code correctly using “List of
remote control codes” at the end of this manual.
44
Try setting another code of the same manufacturer
using “List of remote control codes” at the end of this
manual.
44
If this unit does not work when you press
n
Cursor
,
do the following.
When the key does not work during DVD disc menu
operation: press the
g
Input selection keys
on
the remote control again.
When the key does not work during OPTION menu/
SETUP menu operation: press the key applicable for
the current menu operation again.
—
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
iPod
Problem
Cause
Remedy
See
page
Loading...
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
Connect error
There is a problem with the signal path
from your iPod to this unit.
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit.
16
Remove your iPod in the Yamaha iPod universal dock
and then place it back in the dock.
16
Unknown iPod
The iPod being used is not supported by
this unit.
This unit supports iPod Touch, iPod (Click Wheel),
iPod nano and iPod mini.
—
iPod Connected
Your iPod is properly placed in the
Yamaha iPod universal dock.
Disconnected
Your iPod is removed from the Yamaha
iPod universal dock.
Place your iPod in the Yamaha iPod universal dock.
16