Yamaha WXA-50 WXA-50 Owner s Manual Advanced - Page 40

Problem The unit cannot connect to the Internet via a wireless router (access point). Cause The unit and the wireless router (access point) are too far apart or there is an obstacle between them. Remedy Place the unit and the wireless router (access point) closer to each other or move them to a location where there are no obstacles between them. Bluetooth® Problem Cause The Bluetooth device does not support A2DP. A Bluetooth device that you want to pair with the unit has a password other than "0000". The unit and the Bluetooth device are too far apart. There is a device (such as a microwave or a wireless network device) that outputs signals in the 2.4 GHz frequency band nearby. Cannot make the unit pair with a Bluetooth device. The unit enters standby mode. The wireless switch on the rear panel is turned off. The wireless antenna is not attached. Another Bluetooth device is already connected to the unit. Private Mode is set to "On". In this case, you can connect only a Bluetooth device that has been connected before. Remedy Use a Bluetooth device that supports A2DP. Use a Bluetooth device whose password is "0000". Move the Bluetooth device closer to the unit. Move the unit away from those devices. Turn on the unit and select Bluetooth as the input source, and then perform pairing with the device. Set the wireless switch properly to enable the Bluetooth connection (p.7). Attach the wireless antenna. Terminate the current Bluetooth connection and then establish a new connection. Set Private Mode to "Off" and then connect the new Bluetooth device. 40 En