Yamaha WXA-50 WXA-50 Owner s Manual Advanced - Page 41

Error table of STATUS indicator Refer to the table below when the STATUS indicator on the front panel flashes in error indications. Color Condition Flashing, and the power turns off immediately after the power has been turned on 2 - 8 times Blink Flashing, and the power does not turn on 4 - 8 times Fast flashing Red Flashing (every 0.5 second) * Slow flashing (every 1 second) Once Repeat blinking 2 - 7 times and 1 second off until the unit is turned off Twice 3 times 5 times Repeated until the unit is turned off Orange Flashing Twice White Slow flashing after turning on the unit 10 times * The NET indicator and (Bluetooth) indicator flash at the same time. Status of the unit As a safety precaution, the unit has turned itself off. As a safety precaution, capability to turn on the unit is disabled. Contact your nearest authorized Yamaha dealer or service center to request repair. No presets have been registered. An error occurred during firmware updating. Check the connection of the USB memory device, or the unit to the network, and then update the firmware again. An error is occurring with the USB device. An error is occurring with the network. An error is occurring with WAC/WPS/CONNECT. Firmware update failed. Update the firmware using a USB memory device (p.35). The remote control IDs of the unit and the remote control are not identical, or reception of the remote control signal is disabled. To specify the remote control settings, see "CONFIGURING ADVANCED FEATURES" (p.29, p.32). A new firmware update is available. Update the firmware (p.35). 41 En