ZyXEL NAS326 User Guide - Page 109
Table 40, Label, Description
View all ZyXEL NAS326 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Chapter 10 Control Panel The following table describes the labels in this screen. Table 40 Control Panel > Network > TCP/IP > Network Interface LABEL Status Interface IP Settings IP Address Subnet Mask Create DESCRIPTION Display data transmission rate and transmission system. Display the interface name. Display the IP settings (automatically or manually) of an interface. Display the IP address of an interface. Display the subnet mask of an interface. Click it to open the following screen to set up a port trunking. Automatically For adding a port trunking, see Section 10.4.2.1 on page 110. Select this option to have the interface get IP address information automatically. Manually If no IP address information is assigned, the NAS uses Auto-IP to assign itself an IP address and subnet mask. For example, you could connect the NAS directly to your computer. If the computer is also set to get an IP address automatically, the computer and the NAS will choose addresses for themselves and be able to communicate. Select this option for the interface to use fixed TCP/IP information. You must fill in the following fields. IP Address - Type an IP address in this field. Subnet Mask - Type an IP subnet mask in this field. Create Cancel Edit Default Gateway - Type a default gateway address in this field. Click this to save the settings and create a port trunk. Click this to return to the previous screen without saving. Click this to modify the IPv4 or IPv6 settings of LAN 1 and LAN 2. IPv4 Settings For editing the PPPoE settings, see Section 10.4.2.2 on page 111. Click this to configure the following IPv4 settings. Automatically - Select this option to have the interface get IP address information automatically. Manually - Select this option for the interface to use fixed TCP/IP information. IPv6 Settings • IP Address - Type an IP address in this field. • Subnet Mask - Type an IP subnet mask in this field. • Default Gateway - Type a default gateway address in this field. Click this to configure the following IPv6 settings. Mode - • Select Auto to have the Device use the IPv6 prefix from the connected router's Router Advertisement (RA) to generate an IPv6 address. • Select Manual if you have a fixed IPv6 address assigned by your ISP. • Select Disable to not assign any IPv6 address for the NAS. Address - Enter the IPv6 address assigned by your ISP. Subnet prefix length - Enter the address prefix length to specify how many most significant bits in an IPv6 address compose the network address. The range is 0 to 128 Apply Default Gateway - Enter the IP address of the next-hop gateway. The gateway is a router or switch on the same segment as your Device's interface(s). The gateway helps forward packets to their destinations. Click this to save your TCP/IP configurations. After you click Apply, the NAS restarts. Wait until you see the Login screen or until the NAS fully boots and then use the NAS Starter Utility to rediscover it. Cloud Storage User's Guide 109