ZyXEL NAS326 User Guide - Page 17

Chapter 1 Getting to Know Your NAS Figure 2 Using the Power Button to Turn Off the NAS Press 1 Beep 2 Beeps 3 seconds 2 more seconds Release for software shutdown Release for hardware shutdown • To have the NAS go through its normal software shutdown process and turn itself off, press the power button until you hear one beep (after about three seconds), then release it. • To perform a hardware shutdown and have the NAS immediately turn itself off without going through the normal shutdown process, press the power button until you hear a second beep (after about five seconds), then release it. 1.6 COPY/SYNC Button Use the COPY/SYNC button on the front panel to copy or synchronize files between a connected USB or SD device and the NAS. See Section 17.10 on page 232 for more details on how to configure the copy/sync settings. 1.7 RESET Button Use the RESET button on the rear panel to restore the NAS's default settings. Figure 3 The RESET Button Press 1 Beep 2 Beeps 5 more seconds Release to Reset IP Address Password Release to Clear All Settings • Press the RESET button until you hear one beep (after about two seconds), then release it. You will hear one more beep after you release the button. This resets the NAS's IP address and password to the default values. • Press the RESET button until you hear two beeps. After the second beep, continue pressing the button for five more seconds, then release it. You will hear three quick beeps after you release the button. This resets the NAS to the factory default configuration. All settings you have configured on the NAS, including IP address, password, user accounts, groups, and so on will be reset to the factory defaults. The reset process does NOT affect the volume settings, nor data stored on the NAS. Cloud Storage User's Guide 17