2006 BMW M6 Owner's Manual - Page 185

procedures with correspondingly trained personnel. Due to the high voltage involved, there is a danger to life and limb when work is carried out improperly.< Turn signal lamp 1 Bulb 21 watts, WY 21 SV The illustration shows the front right side of the engine compartment. 1. Press the lever shown: > downward for the right turn signal High beams, parking lamps The illustration shows the front left side of the engine compartment. High beams Bulb 55 watts, H 7 1. Remove the cover cap 1 by pressing the tab and removing the cover cap upward. 2. Press the bulb holder from above to release it. 3. Remove the bulb holder. 4. Remove and replace the bulb. The lamp H7 is pressurized; wear eye protection and protective gloves. Otherwise there is a danger of injuries if the bulb is accidentally damaged during replacement.< 2. Remove the bulb holder towards the rear. Navigation Reference Mobility 183 Online Edition for Part No. 01 41 0 012 118 - © 02/06 BMW AG 3. Remove and replace the bulb. Turn signal lamp 2 Bulb 21 watts, WY 21 SV The bulb for the turn signal lamp 2 can be replaced via the wheel well. The illustration shows the front left side of the vehicle. 1. Steering turned all the way to the left or right. 2. Turn off the light, switch off the ignition and remove the remote control from the ignition lock. 3. Unscrew the bolt 1 with the open-ended wrench from the onboard toolkit, refer to page 182. Parking lamps Bulb 10 watts Bulb holder and reflector are one unit and are replaced together.< 1. Turn the bulb holder 2 to the right and remove. 2. Press the snap connection on the plug connector, pull off the bulb holder and replace. Front turn signal, side marker Your BMW is equipped with two turn signal lamps per side in the front. Communications Entertainment Driving tips Controls > upward for the left turn signal At a glance