1997 Chevrolet Monte Carlo Owner's Manual - Page 265

Care of Safety Belts Keep belts clean and dry. Cleaning the Outside the of Windshield and Wiper Blades If the windshield is not clear after using the windshield washer, or if the wiper blade chatters when running, wax, sap orother material may be on the blade or windshield. Clean the outside of the windshield with GM Windshield Cleaner, BonAmi@Powder (non-scratching glass cleaning powder), GM PartNo. 1050011. The windshield is clean if beads do not form when you rinse it with water. Grime from the windshield will stick to the wiper blades and affect their performance. Clean the blade by wiping vigorously with a cloth soaked in full-strength windshield washer solvent. Then rinse the blade with water. Check the wiper blades and clean them as necessary; replace blades that look worn. U Do not bleach or dye safety belts. If you do, it may severely weaken them. In a crash, they might not be able to provide adequate protection. Clean safety belts only with mild soap and lukewarm water. Cleaning Glass Surfaces Glass should be cleaned often. GM Glass Cleaner (GM Part No. 1050427) or a liquid household glass cleaner will remove normal tobacco smoke and dust films on interior glass. Don't use abrasivecleaners on glass, because they may cause scratches. Avoid placing decals on the inside rear window, since they may have to be scraped off later. If abrasive cleaners are used on the inside of the rear window, an electricdefogger element may be damaged. Any temporary license should not be attached across the defogger grid. Weatherstrips Silicone grease on weatherstrips willmake them last longer, seal better, and not stick squeak. Apply or silicone grease with a clean cloth at least every six months. During verycold, damp weather more frequent application may be required. (See "Recommended Fluids and Lubricants" in the Index.)