2013 Chevrolet Camaro Owner's Manual - Page 124
2013 Chevrolet Camaro Manual
Page 124 highlights
5-26 Instruments and Controls Vehicle Information Menu Items Press the MENU button on the turn signal lever until Vehicle Information Menu is displayed. Use the thumbwheel to scroll through the following menu items: ... since the last time this menu item was reset. The fuel economy can be reset by pressing the SET/CLR button while the Average Fuel Economy display is showing. Average Vehicle Speed The Average Vehicle Speed display shows the average speed of the vehicle in kilometers per hour (km/h) or miles per hour (mph). This average is calculated based on the various vehicle speeds recorded since the last reset of this value. The average speed can be reset by pressing the SET/CLR button while the Average Vehicle Speed display is showing. Turn-by-Turn This display is used for the OnStar Turn-by-Turn guidance. See OnStar Overview on page 14‑1. Blank Display This display shows no information. Tire Pressure The display will show a vehicle with the approximate pressures of all four tires. Tire pressure is displayed in either kilopascal (kPa) or in pounds per square inch (psi). See Tire Pressure Monitor System on page 10‑58 and Tire Pressure Monitor Operation on page 10‑59. Remaining Oil Life This display shows an estimate of the oil's remaining useful life. If REMAINING OIL LIFE 99% is displayed, that means 99% of the current oil life remains. When the remaining oil life is low, the CHANGE ENGINE OIL SOON message will appear on the display. See Engine Oil Messages on page 5‑36. The oil should be changed as soon as possible. See Engine Oil on page 10‑12. In addition to the engine oil life system monitoring the oil life, additional maintenance is recommended in the Unit Tire Pressure Remaining Oil Life Coolant Temp Battery Voltage Speed Warning Unit Move the thumbwheel up or down to switch between US or Metric when the Unit display is active. Press SET/CLR to confirm the setting. This will change the displays on the cluster and DIC to either English (US) or metric measurements.