2014 Chevrolet Silverado 1500 Extended Cab Owner Manual - Page 434
2014 Chevrolet Silverado 1500 Extended Cab Manual
Page 434 highlights
10-70 Vehicle Care 8. Proceed to the passenger side front tire, and repeat the procedure in Step 7. 9. Proceed to the passenger side rear tire, and repeat the procedure in Step 7. 10. Proceed to the driver side rear tire, and repeat the procedure in Step 7. The horn sounds two times to indicate the sensor identification code has been matched to the driver side rear tire, and the TPMS sensor matching process is no longer active. The TIRE LEARNING ACTIVE message on the DIC display screen goes off. 11. Turn the ignition switch to LOCK/OFF. 12. Set all four tires to the recommended air pressure level as indicated on the Tire and Loading Information label. . 5. If the vehicle has an uplevel DIC, press and hold the V (Set/ Reset) button located in the center of the DIC controls. If the vehicle has a base level DIC, press and hold the trip odometer reset stem for about five seconds. A message asking if the process should begin should appear. Select yes and press the trip odometer reset stem to confirm the selection. The horn sounds twice to signal the receiver is in relearn mode and the TIRE LEARNING ACTIVE message displays on the DIC screen. 6. Start with the driver side front tire. 7. Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position. Tire Inspection We recommend that the tires, including the spare tire, if the vehicle has one, be inspected for signs of wear or damage at least once a month. Replace the tire if: . The indicators at three or more places around the tire can be seen. There is cord or fabric showing through the tire's rubber. The tread or sidewall is cracked, cut, or snagged deep enough to show cord or fabric. The tire has a bump, bulge, or split. . .