2012 Chrysler 300 Owner Manual SRT - Page 251
2012 Chrysler 300 Manual
Page 251 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 249 press and release the "LEARN" or "TRAINING" button. On some garage door openers/devices there may be a 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) light that blinks when the garage door opener/device is away from the HomeLink button you wish to program in the LEARN/TRAIN mode. while keeping the HomeLink indicator light in view. NOTE: You have 30 seconds in which to initiate the next 3. Simultaneously press and hold both the Homelink step after the LEARN button has been pressed. button you want to program and the hand-held transmit6. Return to the vehicle and press the programmed ter button. HomeLink button twice (holding the button for two 4. Continue to hold both buttons and observe the indiseconds each time). If the garage door opener/device cator light. The Homelink indicator will flash slowly activates, programming is complete. and then rapidly after Homelink has received the frequency signal from the hand-held transmitter. Release NOTE: If the garage door opener/device does not both buttons after the indicator light changes from slow activate, press the button a third time (for two seconds) to complete the training. to rapid. 1. Turn the ignition switch to the ON/RUN position. 5. At the garage door opener motor (in the garage), To program the remaining two HomeLink buttons, locate the "LEARN" or "TRAINING" button. This can repeat each step for each remaining button. DO NOT usually be found where the hanging antenna wire is erase the channels. attached to the garage door opener/device motor. Firmly 3