2012 Chrysler 300 Owner Manual SRT - Page 253
2012 Chrysler 300 Manual
Page 253 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 251 Reprogramming A Single HomeLink Button to pick up the signal during programming. Similar to this To reprogram a channel that has been previously trained, Canadian law, some U.S. gate operators are designed to follow these steps: time-out in the same manner. 1. Turn the ignition switch to the ON/RUN position. It may be helpful to unplug the device during the cycling 2. Press and hold the desired HomeLink button until process to prevent possible overheating of the garage the indicator light begins to flash after 20 seconds. Do not door or gate motor. release the button. 1. Turn the ignition switch to the ON/RUN position. 3. Without releasing the button proceed with "Program2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) ming A Non-Rolling Code" Step 2 and follow all remainaway from the HomeLink button you wish to program ing steps. while keeping the HomeLink indicator light in view. Canadian/Gate Operator Programming 3. Continue to press and hold the HomeLink button, For programming transmitters in Canada/United States while you press and release ("cycle"), your hand-held that require the transmitter signals to "time-out" after transmitter every two seconds until HomeLink has several seconds of transmission. successfully accepted the frequency signal. The indicator Canadian radio frequency laws require transmitter sig- light will flash slowly and then rapidly when fully nals to time-out (or quit) after several seconds of trans- trained. mission - which may not be long enough for HomeLink 3