2012 Chrysler 300 Owner Manual SRT - Page 413

STARTING AND OPERATING 411 If the ignition switch is cycled, this sequence will repeat, providing the system fault still exists. If the system fault no longer exists, the TPM Telltale Light will no longer flash, and the ЉSERVICE TPM SYSTEMЉ message will no longer display, and a pressure value will display in place of the dashes. A system fault can occur due to any of the following: 4. Using tire chains on the vehicle. 5. Using wheels/tires not equipped with TPM sensors. The EVIC will also display a ЉSERVICE TPM SYSTEMЉ message for a minimum of five seconds when a system fault related to an incorrect sensor location fault is detected. In this case, the ЉSERVICE TPM SYSTEMЉ message is then followed with a graphic display with 1. Signal interference due to electronic devices or driving pressure values still shown. This indicates that the presnext to facilities emitting the same radio frequencies as sure values are still being received from the TPM sensors the TPM sensors. but they may not be located in the correct vehicle 2. Installing aftermarket window tinting that contains position. The system still needs to be serviced as long as materials that may block radio wave signals. the ЉSERVICE TPM SYSTEMЉ message is displayed. 3. Accumulation of snow or ice around the wheels or wheel housings. 5