2011 Dodge Ram 1500 Crew Cab Owner Manual - Page 154
2011 Dodge Ram 1500 Crew Cab Manual
Page 154 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 153 • Place the handheld transmitter 1 to 3 in (3 to 8 cm) NOTE: Some gate operators and garage door openers from the HomeLink buttons while keeping the EVIC may require you to replace Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. display in view. For optimal training, point the battery end of the • Press and hold the just-trained HomeLink button. If the channel has been trained, the EVIC display will handheld transmitter away from the HomeLink now state "CHANNEL # TRANSMIT". • Simultaneously press and hold both the chosen HomeLink button and the handheld transmitter butIf the EVIC display still states "CHANNEL # TRAINton until the EVIC display changes from "CHANNEL ING" repeat Step 3. # TRAINING" to "CHANNEL # TRAINED". NOTE: After training a HomeLink channel, if the Then release both the HomeLink and handheld trans- garage door does not operate with HomeLink and the mitter buttons. garage door opener was manufactured after 1995, the garage door opener may have rolling code. If so, proceed If the EVIC display states "DID NOT TRAIN" repeat to the heading "Programming A Rolling Code System." Step 3. If the signal is too weak, replace the battery in the Programming A Rolling Code System handheld transmitter. At the garage door opener motor (in the garage), locate It may take up to 30 seconds or longer in rare cases. The the "Learn" or "Training" button. garage door may open and close while you train. 3