2011 Dodge Ram 1500 Crew Cab Owner Manual - Page 214

UNDERSTANDING YOUR INSTRUMENT PANEL 213 means the engine oil change interval may fluctuate Lo tirE When the appropriate condition exists, the odometer dependent upon your personal driving style. display will toggle between Lo and tirE for three cycles. Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN noFUSE If the vehicle diagnostic system determines that the position. To turn off the message temporarily, press and Ignition Off Draw (IOD) fuse is improperly installed, or release the Trip Odometer button on the instrument damaged, a "noFUSE" message will display in the odom- cluster. To reset the oil change indicator system (after eter display area. For further information on fuses and performing the scheduled maintenance), refer to the fuse locations refer to "Fuses" in "Maintaining Your following procedure: Vehicle". 1. Turn the ignition switch to the ON/RUN position CHAngE OIL (Do not start the engine). Your vehicle is equipped with an engine oil change 2. Fully depress the accelerator pedal slowly three indicator system. The CHAngE OIL message will flash in times within 10 seconds. the instrument cluster odometer for approximately 12 seconds after a single chime has sounded to indicate 3. Turn the ignition switch to the OFF/LOCK position. the next scheduled oil change interval. The engine oil NOTE: If the indicator message illuminates when you change indicator system is duty cycle-based, which start the vehicle, the oil change indicator system did not reset. If necessary repeat this procedure. 4