1996 Ford Aerostar Owner's Manual - Page 281

u Put the chains on tightly with the ends held down securely. Verify that no chain touches any wiring, brake lines or fuel lines. Retighten the chains after driving 1/2 mile (0.8 km). Follow the chain manufacturer's instructions. u Do not drive faster than 30 mph (48 km/h) or the chain manufacturer's recommended speed limit, whichever is lower. Avoid bumps, holes and sharp turns. If you can hear the chains rub or bang against your vehicle, remove the chains to prevent damage to your vehicle. carefully and avoid hard braking. u Tire chains may affect vehicle handling. Drive u Avoid fully loading your vehicle if possible. u Remove tire chains at the first opportunity u Make sure your suspension insulation and Cleaning the Wheels Wash the wheels with the same detergent you use to wash your vehicle's body. Do not use acid-based wheel cleaners, steel wool, abrasives, fuel, or strong detergents. These substances will damage protective coatings. Use tar and road oil remover to remove grease and tar. NOTE: Before going to a car wash, find out if the brushes are abrasive. after using them on snow and ice. Do not use the chains on dry roads. bumpers are not missing or worn to avoid damage to your vehicle. 303