2012 Ford Focus Owner Guide 5th Printing - Page 134

Driver Controls Windshield washer Pull the control toward you to activate the windshield washer. Release the control to stop washer fluid spray. The wipers will operate for a short time after the washer is turned off. Courtesy wipe feature One extra wipe will happen a few seconds after washing the front window to clear any water that is dripping down from the top of the windshield caused by the washing. Note: Do not operate the washer when the washer reservoir is empty. This may cause the washer pump to overheat. Check the washer fluid level frequently. Do not operate the wipers when the windshield is dry. This may scratch the glass, damage the wiper blades and cause the wiper motor to burn out. Before operating the wiper on a dry windshield, always use the windshield washer. In freezing weather, be sure the wiper blades are not frozen to the windshield before operating the wipers. Windshield wiper rainlamp feature (if equipped with autolamp) When the windshield wipers are turned to low- or high-speed wiping during daylight, and the headlamp control is in the autolamp position, the exterior lamps will turn on after a brief delay and will remain on until the wipers are turned off. Rear window wiper/washer (if equipped) Wiper Press the top of the switch to the first position for intermittent operation. Press the top of the switch to the second position for normal operation. Press the bottom of the switch to turn off. Washer Press the lever forward to operate the washer. The wiper will operate for a short time and will activate once more after pausing to clear the rear window. The rear wiper will automatically turn on to intermittent when you shift into R (Reverse) if the front wipers are activated. 134 2012 Focus (foc) Owners Guide, 5th Printing USA (fus)