2012 Ford Focus Owner Guide 5th Printing - Page 148
2012 Ford Focus Manual
Page 148 highlights
Driver Controls 2. Return to your car. 3. Press and hold the function button you want to program for 2 seconds, then release. Repeat this step. Depending on the brand of garage door opener you may need to repeat this sequence a third time. To program additional buttons repeat steps one through four. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. Gate Operator & Canadian Programming During programming, your hand-held transmitter may automatically stop transmitting - not allowing enough time for HomeLink to accept the signal from the hand-held transmitter. After completing Step 1 outlined in the Programming section, replace Step 2 with the following: Note: If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent overheating. • Continue to press and hold the HomeLink button (note Step 2 in the Programming section) while you press and release - every two seconds ("cycle") your hand-held transmitter until the frequency signal has been accepted by the HomeLink. The indicator light will flash slowly and then rapidly after HomeLink accepts the radio frequency signal. • Proceed with Step 3 in the Programming section. 148 2012 Focus (foc) Owners Guide, 5th Printing USA (fus)