Home » Ford Manuals » 2012 Ford Focus » Manual Viewer

2012 Ford Focus Owner Guide 5th Printing - Page 155

2012 Ford Focus Manual

Get 2012 Ford Focus PDF manuals and user guides

View all 2012 Ford Focus manuals

Page 155 highlights

Locks and Security MyKey௡ is successfully programmed. Make sure you label it so you can distinguish it from the admin keys. Note: To program the optional settings go to Step 2 in the Programming MyKey௡ optional settings section. If your vehicle is equipped with remote start, see the Using MyKey௡ with remote start systems section. Note: All MyKeys௡ can be cleared within the same key cycle that a MyKey௡ was created, otherwise an admin key is required to clear all MyKeys௡. To clear all MyKeys௡ go to Step 2 in the Clear MyKey௡ section. Programming MyKey௡ optional settings Turn the ignition on using an admin key. To program the optional settings, use the message center buttons to do the following: 1. Get into the main menu, select Settings then MyKey by pressing OK or the > button. 2. Use the up or down arrow to get to any optional feature. 3. Press OK or the > button to bring up settings for the selected feature. 4. Press OK or the > button to make your choice. Clear MyKey௡ To reset all MyKeys௡ as admin keys, do the following: 1. Get into the main menu, select Settings then MyKey by pressing OK or the > button. 2. Press the down arrow to get to Clear All and press the OK button. 3. Hold the OK button until ALL MYKEYS CLEARED is displayed. Check MyKey௡ system status The vehicle information will provide the status of the following MyKey௡ parameters: • MYKEY MILES - This odometer only tracks mileage when a MyKey௡ is used. If mileage does not accumulate as expected, then the MyKey௡ is not being used by the intended user. The only way to reset this odometer to zero is by clearing MyKey௡. If this odometer is lower than the last time you checked, then the MyKey௡ system has been recently cleared. • # MYKEY(S) - Indicates how many MyKeys௡ are programmed to the vehicle. Can be used to detect deletion of a MyKey௡. • # ADMIN KEY(S) - Indicates how many admin keys are programmed to the vehicle. Can be used to detect if an additional spare key has been programmed to the vehicle. Refer to Message center in the Instrument Cluster chapter for vehicle information displays. 155 2012 Focus (foc) Owners Guide, 5th Printing USA (fus)

Section	Page
Table of Contents	1
Introduction	4
CONGRATULATIONS	4
SAFETY AND ENVIRONMENT PROTECTION	4
Warning symbols in this guide	4
Warning symbols on your vehicle	5
Protecting the environment	5
CALIFORNIA PROPOSITION 65 WARNING	5
PERCHLORATE MATERIAL	5
BREAKING-IN YOUR VEHICLE	5
SPECIAL NOTICES	6
New Vehicle Limited Warranty	6
Special instructions	6
DATA RECORDING	6
Service Data Recording	6
Event Data Recording	7
CELL PHONE USE	9
EXPORT UNIQUE (NON–UNITED STATES/CANADA) VEHICLE SPECIFIC INFORMATION	9
Instrument Cluster	12
WARNING LIGHTS AND CHIMES	12
GAUGES	17
BASE MESSAGE CENTER (IF EQUIPPED)	18
Menu	19
System Check	21
System warnings and status messages	21
UP-LEVEL MESSAGE CENTER (IF EQUIPPED)	22
Main menu	22
System Check	26
System warnings and status messages	26
SYSTEM WARNINGS AND STATUS MESSAGES	26
Entertainment Systems	37
AUDIO SYSTEMS	37
AM/FM/CD/MP3 system (if equipped)	37
AM/FM//CD/MP3 satellite radio and SYNC? compatible (if equipped)	40
AM/FM/CD/MP3 SYNC? compatible system (if equipped)	45
MyFord Touch™	49
Auxiliary input jack (Line in, if equipped)	49
USB Port	51
Media hub (if equipped)	51
GENERAL AUDIO INFORMATION	52
Satellite Radio Information (If Equipped)	53
Satellite Radio Channels	53
Satellite Radio Reception Factors	54
SIRIUS? Satellite Radio Service	54
Satellite Radio Electronic Serial Number (ESN)	54
Troubleshooting	55
SYNC? (IF EQUIPPED)	57
Added benefits	58
Support	58
Driving restrictions	58
Safety information	59
Privacy information	59
Using your voice recognition system	60
Initiating a voice session	60
System interaction and feedback	61
Adjusting the interaction level	61
Using SYNC?’s phone features	62
Phone dependent features	62
Pairing a phone for the first time	63
Pairing subsequent phones	64
Phone voice commands	64
Making a call	66
Answering an incoming call	66
Phone options during an active call	67
Maneuvering the phone menu	69
Accessing features through the phone menu	70
Text messaging	72
Receiving a text message	72
Sending, downloading and deleting your text messages	72
Accessing your phone settings	74
System settings	75
Bluetooth Device menu options	77
Advanced menu options	78
Accessing and using your SYNC applications and Services (if equipped)	80
SYNC? Services: Traffic, Directions & Information (TDI), if equipped, U.S. only	80
	911

Match case Limit results 1 per page

MyKey

is successfully programmed. Make sure you label it so you can

distinguish it from the admin keys.

Note:

To program the optional

settings go to Step 2 in the

Programming MyKey

optional settings

section. If your vehicle is equipped with remote start, see the

Using

MyKey

with remote start systems

section.

Note:

All MyKeys

can be cleared within the same key cycle that a

MyKey

was created, otherwise an admin key is required to clear all

MyKeys

. To clear all MyKeys

go to Step 2 in the

Clear MyKey

section.

Programming MyKey

optional settings

Turn the ignition on using an admin key. To program the optional

settings, use the message center buttons to do the following:

1. Get into the main menu, select Settings then MyKey by pressing OK

or the > button.

2. Use the up or down arrow to get to any optional feature.

3. Press OK or the > button to bring up settings for the selected feature.

4. Press OK or the > button to make your choice.

Clear MyKey

To reset all MyKeys

as admin keys, do the following:

1. Get into the main menu, select Settings then MyKey by pressing OK

or the > button.

2. Press the down arrow to get to Clear All and press the OK button.

3. Hold the OK button until ALL MYKEYS CLEARED is displayed.

Check MyKey

system status

The vehicle information will provide the status of the following MyKey

parameters:

•

MYKEY MILES — This odometer only tracks mileage when a MyKey

used. If mileage does not accumulate as expected, then the MyKey

is not

being used by the intended user. The only way to reset this odometer to

zero is by clearing MyKey

. If this odometer is lower than the last time

you checked, then the MyKey

system has been recently cleared.

•

# MYKEY(S) — Indicates how many MyKeys

are programmed to the

vehicle. Can be used to detect deletion of a MyKey

•

# ADMIN KEY(S) — Indicates how many admin keys are programmed

to the vehicle. Can be used to detect if an additional spare key has

been programmed to the vehicle.

Refer to

Message center

in the

Instrument Cluster

chapter for vehicle

information displays.

Locks and Security

155

2012 Focus

(foc)

Owners Guide, 5th Printing

USA

(fus)