2014 Ford C-MAX Energi Owner Manual - Page 153

High Voltage Battery When waiting to charge (not actively charging), the light ring will indicate the present state of charge of the high voltage battery as follows: • When the top right quadrant light is off, the charge is between 0-25 percent. • When the top right quadrant light is on and the bottom right quadrant is off, the charge is between 25-50 percent. • When both right side quadrant lights are on and the bottom left quadrant is off, the charge is between 50-75 percent. • When three quadrant lights are on and the top left quadrant is off, the charge is between 75-100 percent. • When all lights on the entire ring are on, the charge is 100 percent. Note: When the vehicle is waiting to charge, the light ring will turn off one minute after displaying the present state of charge. When the vehicle automatically begins charging, the light ring will turn on and display how far along the charge is per the section above. Note: If the system detects a vehicle charging system fault at any point in a charge cycle, the entire light ring will flash continuously for one minute and then turn off. If this happens, unplug the charging coupler and then plug it back into the charge port receptacle. If the problem persists, contact your authorized dealer. You can modify the light ring lighting conditions. See Charge Port Light Ring Settings in the MyFord Touch section. See MyFord Touch™ (page 322). Disconnecting the Charging Coupler Note: Do not pull the wall plug from the wall while the vehicle is charging. Doing so may damage the outlet and the cord. 1. Remove the lock from the charging coupler button. 2. Press the button on the charging coupler. 3. While holding the button, remove the charging coupler from the charge port receptacle on your vehicle. E144781 4. Close the charge port door by pressing the indentation on the charge port door. Continue pressing the indentation while the door rotates counterclockwise and closes. HIGH VOLTAGE BATTERY CUTOFF SWITCH The high-voltage shut off operation shuts off power from the high-voltage battery after a collision, or if your vehicle receives a substantial physical jolt. To reactivate the vehicle after either event perform the following steps: 1. Turn the ignition off. 2. Turn the ignition on. 3. If the vehicle is not powered after this sequence, repeat steps 1 and 2. For vehicles equipped with a push button start system: Press the START/STOP button to turn ignition off. 2. Press the brake pedal and press the START/STOP button. 1. 151 C-MAX (CCG)