2014 Ford C-MAX Energi Owner Manual - Page 215

Maintenance 4. After three seconds, the Service: Oil reset in prog. message will be displayed. 5. After 25 seconds, the Service: Oil reset complete message will be displayed. 6. Release both the accelerator and brake pedals. 7. The Service: Oil reset complete message will no longer be displayed. 8. Rotate the key to the off position. For vehicles with push-button start, press the start button to turn the vehicle off completely. The coolant concentration should be maintained within 48% to 50%, which equates to a freeze point between -30°F (-34°C) and -34°F (-37°C). Note: For best results, coolant concentration should be tested with a refractometer such as Rotunda tool 300-ROB75240 available from your dealer. Ford does not recommend the use of hydrometers or coolant test strips for measuring coolant concentrations. Note: Automotive fluids are not interchangeable. Do not use engine coolant or antifreeze or windshield washer fluid outside of its specified function and vehicle location. ENGINE COOLANT CHECK Engine Coolant and Inverter System Controller Coolant Your vehicle is equipped with two separate cooling systems. One is for cooling the engine and one is for cooling the inverter system controller that is specific to the hybrid operating system. The two systems operate similarly, with the inverter system controller cooling system generally operating at a lower temperature and pressure. Checking the Inverter System Controller Coolant When the engine is cold, check the concentration and level of the inverter system controller coolant at the intervals listed in the scheduled maintenance information. See Scheduled Maintenance (page 417). Note: Make sure that the level is between the MIN and MAX marks on the inverter system controller coolant reservoir. Note: Coolant expands when it is hot. The level may extend beyond the MAX mark. Note: If the level is at the MIN mark, below the MIN mark, or empty, add prediluted coolant immediately. See Adding Inverter System Controller Coolant in this chapter. The coolant concentration should be maintained within 48% to 50%, which equates to a freeze point between -30°F (-34°C) and -34°F (-37°C). Checking the Engine Coolant When the engine is cold, check the concentration and level of the engine coolant at the intervals listed in the scheduled maintenance information. See Scheduled Maintenance (page 417). Note: Make sure that the level is between the MIN and MAX marks on the engine coolant reservoir. Note: Coolant expands when it is hot. The level may extend beyond the MAX mark. Note: If the level is at the MIN mark, below the MIN mark, or empty, add prediluted coolant immediately. See Adding Engine Coolant in this chapter. 213 C-MAX (CCG)