2014 Ford C-MAX Energi Owner Manual - Page 214

Maintenance ENGINE OIL DIPSTICK A B E142732 E169062 A B MIN MAX ENGINE OIL CHECK Note: Check the level before starting the engine. Note: Make sure that the level is between the MIN and the MAX marks. 1. Make sure that your vehicle is on level ground. 2. Turn the engine off and wait 10 minutes for the oil to drain into the oil pan. 3. Remove the dipstick and wipe it with a clean, lint-free cloth. Replace the dipstick and remove it again to check the oil level. If the level is at the MIN mark, add oil immediately. Only use oils certified for gasoline engines by the American Petroleum Institute (API). An oil with this trademark symbol conforms to the current engine and emission system protection standards and fuel economy requirements of the International Lubricants Specification Advisory Council (ILSAC), comprised of U.S. and Japanese automobile manufacturers. 1. Remove the filler cap. 2. Add engine oil that meets the Ford specifications. See Capacities and Specifications (page 265). 3. Replace the filler cap. Turn it until you feel a strong resistance. Resetting the Oil Life Monitoring System Note: Reset the oil life monitoring only after an oil change. 1. Turn the ignition key to the on position. Do not start the engine. For vehicles with push-button start, press and hold the start button for two seconds without pressing the brake pedal. Do not attempt to start the engine. 2. Press both the accelerator and brake pedals at the same time. 3. Keep both pedals fully pressed. Adding Engine Oil Note: Do not remove the filler cap when the engine is running. Note: Do not add oil further than the MAX mark. Oil levels above the MAX mark may cause engine damage. 212 C-MAX (CCG)