2014 Ford C-MAX Energi Owner Manual - Page 224
2014 Ford C-MAX Energi Manual
Page 224 highlights
Maintenance REMOVING A HEADLAMP 2 2 E142465 4. On the wall or screen you will observe a flat zone of high intensity light located at the top of the right hand portion of the beam pattern. If the top edge of the high intensity light zone is not at the horizontal reference line, the headlamp will need to be adjusted. E142468 1. 2. 3. 4. 5. Make sure the headlamp control is in the off position and open the hood. Remove the two screws from the headlamp assembly. Carefully pull the headlamp assembly as far as possible towards the front of the vehicle to disengage it from the lower fixing point. Carefully lift the outer side of the headlamp and remove it. Disconnect the electrical connector. CHANGING A BULB E142467 Lamp Assembly Condensation Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. When normal condensation occurs, a thin film of mist can form on the interior of the lens. The thin mist eventually clears and exits through the vents during normal operation. Clearing time may take as long as 48 hours under dry weather conditions Examples of acceptable condensation are: 5. Locate the vertical adjuster on each headlamp. Using a Phillips #2 screwdriver, turn the adjuster either clockwise or counterclockwise in order to aim the headlamp. The horizontal edge of the brighter light should touch the horizontal reference line. 6. Close the hood and turn off the lamps. Horizontal Aim Adjustment Horizontal aim is not required for this vehicle and is non-adjustable. 222 C-MAX (CCG)