2010 Infiniti FX50 Owner's Manual - Page 283
2010 Infiniti FX50 Manual
Page 283 highlights
VOICE RECOGNITION SYSTEM You can also use the Bluetooth hands-free phone system with Voice Recognition System. INFO ● The available voice commands are only applicable to the relevant language set in the LANGUAGE setting screen. (See "HOW TO USE SETTING BUTTON" earlier in this section.) SAA2634 Before starting : To get the best performance out of the Voice Recognition System, observe the following: ● Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate the surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing the voice commands correctly. ● Wait until a tone sounds before speaking a command. ● Speak a voice command within 5 seconds after the beep sound. If no voice command is given, the system will ask you for a number. If no further command is given, the session ends. ● Speak in a natural voice without pausing between words. CONTROL BUTTONS 1. PHONE SEND button Push the button to initiate a VR session or answer an incoming call. You can also use the button to skip through system feedback and to enter commands during a call. button 2. PHONE END Push the button to cancel a VR session or end a call. ● If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. Using system Initialization : When the ignition switch is pushed to the ON position, Voice Recognition System is initialized, which takes a few seconds. When completed, the system is ready to accept voice switch on the steering commands. If the wheel is pushed before the initialization completes, the system will not accept any command. Monitor, climate, audio, phone and voice recognition systems 4-117