2010 Infiniti FX50 Owner's Manual - Page 478
2010 Infiniti FX50 Manual
Page 478 highlights
INSTALLING FRONT LICENSE PLATE Use the following steps to mount the license plate. Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag. Only use the recommended mounting position, otherwise Intelligent Cruise Control (ICC) sensor obstruction (if so equipped) may result. ● License plate bracket ● J-nut × 2 ● Screw × 2 ● Screw grommet × 2 1. Park the vehicle on flat, level ground. 2. Locate the center position indicator A on the lower part of the grille. Line up the marks under the top of the front bumper B with the tabs C on the license plate bracket. Hold the license plate bracket in place. 3. Mark the center of the hole C with a felt-tip pen. 4. Carefully drill two pilot holes using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the bumper fascia.) 5. Insert grommets into the hole on the fascia. STI0585 9-14 Technical and consumer information