2010 Infiniti FX50 Owner's Manual - Page 375

Setting DCA system to ON/OFF: 1. Push the SETTING 1 button and highlight the "Driver Assistance" key on the display using the INFINITI controller. Then push the ENTER 2 button. 2. Highlight the "Dynamic Assistance settings" key, and push the ENTER 2 button. SSD0886 SSD0771 3. To set the DCA system to on or off, highlight the "Distance Control Assist" key, select ON or OFF and push the ENTER 2 button. If both the LDP and DCA systems are set to OFF on the display, when the DCA switch is pushed, the LDP ON indicator light and the Distance Control Assist (DCA) system switch indicator light will blink for approximately 2 seconds. See "LANE DEPARTURE WARNING (LDW) SYSTEM/LANE DEPARTURE PREVENTION (LDP) SYSTEM" earlier in this section. Under the following conditions, the Distance Control Assist system will not operate and the Distance Control Assist (DCA) system switch indicator light will blink: ● When the SNOW mode switch is ON (To use the DCA system, turn off the SNOW mode switch, then turn on the DCA switch.) For details about the SNOW mode switch, see "SNOW MODE SWITCH" in the "2. Instruments and controls" section. ● When the VDC system is off (To use the DCA system, turn on the VDC, then push the DCA switch.) For details about the VDC system, see "VEHICLE DYNAMIC CONTROL (VDC) SYSTEM" later in this section. Starting and driving 5-55