2010 Infiniti FX50 Owner's Manual - Page 365

● Do not attach a sticker (including transparent material) or install an accessory near the sensor. This could cause failure or malfunction. CONVENTIONAL (FIXED SPEED) CRUISE CONTROL MODE This mode allows driving at a speed between 25 to 90 MPH (40 to 144 km/h) without keeping your foot on the accelerator pedal. WARNING SSD0621 SSD0738 Condition C : When the ICC system is not operating properly, the chime sounds and the system warning light (orange) will come on. Action to take : If the warning light comes on, park the vehicle in a safe place. Turn the engine off, restart the engine, resume driving and set the ICC system again. If it is not possible to set the system or the indicator stays on, it may indicate that the system is malfunctioning. Although the vehicle is still driveable under normal conditions, have the vehicle checked at an INFINITI retailer. Sensor maintenance The sensor for the ICC system A is located below the front bumper. To keep the ICC system operating properly, be sure to observe the following: ● Always keep the sensor clean. Wipe with a soft cloth carefully so as not to damage the sensor. ● Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on the sensor. Doing so could cause failure or malfunction. If the sensor is damaged due to an accident, contact an INFINITI retailer. ● In the conventional (fixed speed) cruise control mode, a warning chime does not sound to warn you if you are too close to the vehicle ahead, as neither the presence of the vehicle ahead nor the vehicle-to-vehicle distance is detected. ● Pay special attention to the distance between your vehicle and the vehicle ahead of you or a collision could occur. ● Always confirm the setting in the Intelligent Cruise Control system display. ● Do not use the conventional (fixed speed) cruise control mode when driving under the following conditions: - when it is not possible to keep the vehicle at a set speed Starting and driving 5-45