2010 Infiniti FX50 Owner's Manual - Page 357

SSD0916 SSD0784 SSD0614 To set cruising speed, accelerate your vehicle to the desired speed, push the SET/COAST switch and release it. (Vehicle ahead detection indicator, set distance indicator and set vehicle speed indicator come on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed. When the SET/COAST switch is pushed under the following conditions, the system cannot be set and the ICC indicators will blink for approximately 2 seconds: ● When traveling below 20 MPH (32 km/h) and the vehicle ahead is not detected ● When the selector lever is not in the D, DS or Manual mode ● When the windshield wipers are operating at low (LO) or high speed (HI). If the vehicle is equipped with a rain-sensing auto wiper, the system may cancel when the wipers are operating at the intermittent (INT) speed. ● When the parking brake is applied ● When the brakes are operated by the driver When the SET/COAST switch is pushed under the following conditions, the system cannot be set. A warning chime will sound and the ICC indicators will blink. ● When the SNOW mode switch is ON (To use the ICC system, turn off the SNOW mode switch, push the MAIN switch to turn off the ICC and reset the ICC switch by pressing the MAIN switch again.) For details about the SNOW mode switch, see "SNOW MODE SWITCH" in the "2. Instruments and controls" section. Starting and driving 5-37