2014 Jeep Wrangler Owner Manual - Page 171

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169 NOTE: • If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the indicator bulb is defective. High/Low Beam Switch Push the multifunction lever away from you to switch the headlights to high beam. Pull the lever toward you, to switch the headlights back to low beam. Flash-To-Pass 3 You can signal another vehicle with your headlights by • A tone will chime if the turn signals are left on for more lightly pulling the multifunction lever toward you. This than 1 mile (2 km). will turn on the high beams headlights until the lever is released. Lane Change Assist Tap the lever up or down once, without moving beyond Front Fog Lights the detent, and the turn signal (right or left) will flash three times then automatically turn off. The front fog light switch is located on the multifunction lever. To activate the front fog lights, turn Lights-On Reminder on the parking or low beam headlights and pull out the If the headlights or parking lights are left on after the end of the lever. ignition is turned OFF, a chime will sound to alert the driver when the driver's door is opened.