2014 Jeep Wrangler Owner Manual - Page 93

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 91 WARNING! Never use the same lower anchorage to attach more than one child restraint. If you are installing LATCHcompatible child restraints next to each other, you must use the seat belt for the center position. You can then use either the LATCH anchors or the vehicle's seat belt for installing child seats in the outboard positions. Please refer to "Installing The LATCHCompatible Child Restraint System" for typical installation instructions. belt following the instructions below. See the section "Installing Child Restraints Using the Vehicle Seat Belt" to check what type of seat belt each seating position has. 2. Loosen the adjusters on the lower straps and on the tether strap of the child seat so that you can more easily attach the hooks or connectors to the vehicle anchorages. 2 3. Place the child seat between the lower anchorages for that seating position. For some second row seats, you may need to recline the seat and/or raise the head Always follow the directions of the child restraint restraint to get a better fit. If the rear seat can be moved manufacturer when installing your child restraint. Not forward and rearward in the vehicle, you may wish to all child restraint systems will be installed as described move it to its rear-most position to make room for the here. child seat. You may also move the front seat forward to allow more room for the car seat. To Install A LATCH-compatible Child Restraint 1. If the selected seating position has a Switchable Automatic Locking Retractor (ALR) seat belt, stow the seat