2014 Jeep Wrangler Owner Manual - Page 22

20 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE procedure. This procedure consists of programming a 3. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON/RUN position blank key to the vehicle electronics. A blank key is one within 15 seconds. After 10 seconds, a chime will that has never been programmed. sound. In addition, the Vehicle Security Light will NOTE: When having the Sentry Key® Immobilizer Sysbegin to flash. Turn the ignition switch to the LOCK tem serviced, bring all vehicle keys with you to an position and remove the second key. authorized dealer. 4. Insert a blank Sentry Key® into the ignition switch. Customer Key Programming Turn the ignition switch to the ON/RUN position within 60 seconds. After 10 seconds, a single chime If you have two valid Sentry Keys®, you can program will sound. In addition, the Vehicle Security Light will new Sentry Keys® to the system by performing the stop flashing. To indicate that programming is comfollowing procedure: plete, the Vehicle Security Light will turn on again for 1. Cut the additional Sentry Key® Transponder blank(s) three seconds and then turn off. to match the ignition switch lock cylinder key code. The new Sentry Key® is programmed. The Remote 2. Insert the first valid key into the ignition switch. Turn Keyless Entry (RKE) transmitter will also be prothe ignition switch to the ON/RUN position for at grammed during this procedure. least three seconds, but no longer than 15 seconds. Repeat this procedure to program up to eight keys. If you Then, turn the ignition switch to the LOCK position do not have a programmed Sentry Key®, contact your and remove the first key. authorized dealer for details.