2014 Jeep Wrangler Owner Manual - Page 438

436 STARTING AND OPERATING rear wheels to rotate at the same speed. The 4H and 4L positions are intended for loose, slippery road surfaces only and not intended for normal driving. Driving in the 4H and 4L positions on hard-surfaced roads will cause increased tire wear and damage to the driveline components. Refer to "Shifting Procedures" in this section for further information on shifting into 4H or 4L. When operating your vehicle in 4L, the engine speed will be approximately three times (four times for Rubicon models) that of the 2H or 4H positions at a given road speed. Take care not to overspeed the engine. Proper operation of four-wheel drive vehicles depends on tires of equal size, type, and circumference on each wheel. Any difference will adversely affect shifting and The "4WD Indicator Light" (located in the instrument cause damage to the transfer case. cluster) alerts the driver that the vehicle is in four-wheel Because four-wheel drive provides improved traction, drive, and the front and rear driveshafts are locked there is a tendency to exceed safe turning and stopping together. The light will illuminate when the transfer case speeds. Do not go faster than road conditions permit. is shifted into the 4H position. NOTE: Do not attempt to shift when only the front or rear wheels are spinning. The transfer case is not equipped with a synchronizer, and the front and rear driveshaft speeds must be equal for a shift to take place. Shifting while only the front or rear wheels are spinning can cause damage to the transfer case. WARNING! You or others could be injured if you leave the vehicle unattended with the transfer case in the NEUTRAL (N) position without first fully engaging (Continued)