Acer Altos 500 aa500ug.pdf - Page 83
When to Use the SCSI, Utility, Running the SCSI, To start SCSI
![]() |
View all Acer Altos 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
3.1.3 When to Use the SCSISelect Utility Use the SCSISelect utility if you need to • Change any of the default values listed in the settings table • Check and/or change SCSI device settings that may conflict with those of other devices (e.g., SCSI ID) • Perform low-level formatting on new SCSI disk devices 3.1.4 Running the SCSISelect Utility To start SCSISelect, press Ctrl+A when the following is displayed during power-up or reset: Press for SCSISelect Utility! This message appears after BIOS and POST information displays, and after the banner listing the Adaptec AHA-3950U2B version number. Chapter 3 - SCSISelect Configuration Utility 3-3
![](/manual_guide/products/acer-computers-altos-500-aa500ugpdf-76fe80f/83.png)
Chapter 3 – SCSISelect Configuration Utility
3-3
3.1.3
When to Use the SCSI
Select
Utility
Use the SCSI
Select
utility if you need to
•
Change any of the default values listed in the settings table
•
Check and/or change SCSI device settings that may conflict with those of
other devices (e.g., SCSI ID)
•
Perform low-level formatting on new SCSI disk devices
3.1.4
Running the SCSI
Select
Utility
To start SCSI
Select
, press
Ctrl+A
when the following is displayed during power-up
or reset:
Press <Ctrl> <A> for SCSI
Select
Utility!
This message appears after BIOS and POST information displays, and after the
banner listing the Adaptec AHA-3950U2B version number.