Alpine INE-W940 Owner's Manual - Audio (english) - Page 87
Installation, Mounting the Microphone. - gps antenna
View all Alpine INE-W940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Installation Caution Do not block the unit's fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire. Air ventilation hole Heat sink 3 Mounting the Microphone. For safe use, make sure of the following: • location is stable and firm. • driver's view and operations are not obstructed. • microphone is located where the driver's voice can be easily picked up (on the sun visor, etc.). When you speak into the microphone, you should not have to change your driving posture. This may cause a distraction, taking your attention away from safely driving your vehicle. Carefully consider direction and distance while mounting the microphone. Confirm that the driver's voice can be easily picked up at the selected location. Rear of the Unit Caution concerning the installation location 1 Angle of installation Install at an angle between horizontal and 30°. Note that installing at an angle outside of this range will result in a loss of performance and possibly damage. 0 -30° Cable clamp (Sold separately) Microphone 4 Remove the mounting sleeve from the main unit (see "Removal" on page 88). Slide the unit into the mounting sleeve and secure it. Mounting Sleeve (Included) Dashboard This unit 2 Mounting the GPS Antenna inside the vehicle. 1 Clean the mounting location. 2 Put on the GPS Antenna mounting plate. 3 Mount the GPS Antenna. Pressure Plates*1 GPS Antenna Antenna mounting plate • Mount the GPS Antenna on a flat plane of the dash board or rear tray. • Some thermal reflection type or thermal absorption type glass may interrupt high frequency waves. If reception is poor with the antenna installed inside the car, try to mount the antenna outside the car. • Make sure the GPS Antenna is not covered (obstructed) by any metallic surface or object. Face Plate*2 (Included) *1 If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem. *2 The supplied face plate may be mounted. 87-EN