Alpine INE-W940 Owner's Manual - Audio (english) - Page 91

Radio Antenna Receptacle Video Input Connector (AUX INPUT) (Yellow) Input the video. Audio Input Connectors (AUX INPUT) RED is right and WHITE is left input the audio. Rear Output RCA Connectors It can be used as Rear Output RCA Connectors. RED is right and WHITE is left. Front Output RCA Connectors It can be used as Front Output RCA Connectors. RED is right and WHITE is left. Subwoofer RCA Connectors RED is right and WHITE is left. RCA Extension Cable (sold separately) CAMERA Input RCA Connector (Yellow) Use when connecting a camera with RCA Output Connector. Remote Control Output Lead (Brown) Connect this lead to the remote control input lead. This lead outputs the controlling signals from the remote control. Illumination Lead (Orange) This lead may be connected to the vehicle's instrument cluster illumination lead. This will allow the backlighting of the INE-W940/INE-NAV-40/INE-W940S to dim whenever the vehicle's lights are turned on. GPS antenna Receptacle Connect to separately sold GPS antenna (included). SiriusXM Tuner Input Connector (INE-W940/INE-NAV40 only) iPod VIDEO Input Connector Input the iPod/ iPhone video signal or AUX video/audio signal. • Set "AUX3 In Sel." (page 44) to "iPod Video" when an iPod/iPhone is connected. • Set "AUX3 In Sel." (page 44) to "AUX3" when AUX video/ audio is input. USB Connector To USB Memory or iPod/iPhone. MIC Input Connector To Microphone (Included). Steering Remote Control Interface Connector To steering remote control interface box. For details about connections, consult your nearest Alpine dealer. AUX/PRE OUT Connector Power Supply Connector Remote Turn-On Lead (Blue/White) Connect this lead to the remote turn-on lead of your amplifier or signal processor. Reverse Lead (Orange/White) Connect to the plus side of the car's reverse lamp. This lamp illuminates when the transmission is shifted into reverse (R). With this lead properly wired, the video picture automatically switches to the rear camera whenever the car is put into reverse (R). Power Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicable. • This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc. Parking Brake Lead (Yellow/Blue) Connect this lead to the power supply side of the parking brake switch to transmit the parking brake status signals to the INE-W940/INE-NAV-40/INE-W940S. Foot Brake Lead (Yellow/Black) Connect to the vehicle's foot brake lead or brake lamp lead. Switched Power Lead (Ignition) (Red) Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+) 12V only when the ignition is turned on or in the accessory position. Battery Lead (Yellow) Connect this lead to the positive (+) post of the vehicle's battery. Fuse Holder (15A) Ground Lead (Black) Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided. Left Rear (+) Speaker Output Lead (Green) Left Rear (-) Speaker Output Lead (Green/Black) Left Front (+) Speaker Output Lead (White) Left Front (-) Speaker Output Lead (White/Black) Right Front (-) Speaker Output Lead (Gray/Black) Right Front (+) Speaker Output Lead (Gray) Right Rear (-) Speaker Output Lead (Violet/Black) Right Rear (+) Speaker Output Lead (Violet) 91-EN