Alpine iLX-107 Owners Manual - Page 19

Display Setup Display Setup Operation Switching Display Modes Setting item: Display Mode Setting contents: WIDE (Initial setting) / NORMAL To display the Display Setup Menu screen: Your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedures below. 1 Bring your vehicle to a complete stop at a safe location. Engage the parking brake. 2 Release the parking brake. (For safety, release the parking brake while depressing the foot brake pedal). 3 Engage the parking brake again. • For automatic transmission vehicles, place the transmission lever in the Park position. Now, the locking system for the Setup operation has been released. Engaging the parking brake can reactivate the Display Setup Menu, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3) of "To display the Display Setup Menu screen." Each time the ignition is turned OFF, perform the procedure of "To display the Display Setup Menu screen." The following steps 1 to 6 are common operations to each "Setting item" of Display Setup. Refer to each section for details. 1 Touch [ ] on the Home screen. 2 The Setup main screen is displayed. Touch [Display]. The Display Setup screen appears. • You can display the Display Setup screen from each application screen. Touch [ ] on any application screen (video mode). 3 Touch the desired application. • "Auxiliary (AUX)" can be selected while in AUX mode. • The camera names set under the "Camera" settings are displayed. The camera names are not displayed when "Off" is set (page 22). 4 Touch [ ] of the desired item. Settable items differ depending on the application. [Auxiliary (AUX)]: Display Mode / Brightness / Color / Contrast / Sharpness [Camera]: Brightness / Color / Contrast 5 Touch [ ] or [ ] to change its setting. 6 Touch [ ] to return to the main application screen. Touch [ ] to return to the previous screen. • Immediately after changing the settings of Display Setup (While the system is writing data automatically) do not turn the ignition key to OFF. Otherwise, the settings may not be changed. In WIDE mode, the picture is stretched horizontally to fill the entire display. In NORMAL mode, the monitor displays a normal picture at the center of the screen with a vertical black band at each side. Adjusting Brightness Setting item: Brightness Setting contents: -15 to +15 (Initial setting: 0) You can adjust the brightness between MIN (-15) and MAX (+15). When it reaches the minimum or maximum point, the display shows "MIN" or "MAX" respectively. Adjusting Color of Picture Setting item: Color Setting contents: -15 to +15 (Initial setting: 0) You can adjust the Color between MIN (-15) and MAX (+15). When it reaches the minimum or maximum point, the display shows "MIN" or "MAX" respectively. Adjusting Image Contrast Setting item: Contrast Setting contents: -15 to +15 (Initial setting: 0) You can adjust the contrast between MIN (-15) and MAX (+15). When it reaches the minimum or maximum point, the display shows "MIN" or "MAX" respectively. Adjusting Picture Quality Setting item: Sharpness Setting contents: -3 to +3 (Initial setting: 0) Picture quality adjustment range is -3 to +3. "SOFT" and "HARD" appear as the minimum and maximum values. 19-EN