Alpine iLX-107 Owners Manual - Page 28

Information Product Software Update This product uses software that can be updated through a Flash Memory device. Download the software from the Alpine website and update the product using the Flash Memory device. Updating this product Check the Alpine website for details on updating. http://www.alpine-usa.com Important information on the software About the software license of the product The software installed in the product contains opensource software. See the following Alpine website for details on the open source software. http://www.alpine.com/e/oss/download In Case of Difficulty If you encounter a problem, please turn the power off, then on again. If the unit is still not functioning normally, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected, or then consult your authorized Alpine dealer. Basic No function or display. • Vehicle's ignition is off. - If connected according to the instructions, the unit will not operate with the vehicle's ignition off. • Improper power lead connections. - Check power lead connections. • Blown fuse. - Check the fuse of the unit; replace with the proper value if necessary. • Internal micro-computer malfunctioned due to interference noise, etc. - Turn the ignition key off, and then set to ON again. No sound or unnatural sound. • Incorrect setting of volume/balance/fader controls. - Readjust the controls. • Connections are not properly or securely made. - Check the connections and firmly connect. Screen not displayed. • Brightness/Contrast control is set at the minimum position. - Adjust the Brightness/Contrast control. • Temperature in the vehicle is too low. - Increase the vehicle's interior temperature to operation temperature range. • Connections to the Auxiliary Device are not securely made. - Check the connections and firmly connect. • The Parking Brake Lead is not connected. • The Parking Brake is not engaged. - Connect the Parking Brake Lead, then engage the Parking Brake. Movement of displayed picture is abnormal. • Temperature in the vehicle is too high. - Allow the vehicle's interior temperature to cool. Screen changed automatically. • Demonstration function is set to "ON". - Set the Demonstration function to "OFF". (Page 22) Radio Unable to receive stations. • No antenna, or open connection in the antenna cable. - Make sure the antenna is properly connected; replace the antenna or cable if necessary. Unable to tune stations in the seek mode. • You are in a weak signal area. - Make sure the tuner is in DX mode. • If the area you are in is a primary signal area, the antenna may not be grounded and connected properly. - Check your antenna connections; make sure the antenna is properly grounded at its mounting location. • The antenna may not be the proper length. - Make sure the antenna is fully extended; if broken, replace the antenna with a new one. Broadcast is noisy. • The antenna is not the proper length. - Extend the antenna fully; replace it if it is broken. • The antenna is poorly grounded. - Make sure the antenna is grounded properly at its mounting location. • The station signal is weak and noisy. - If above solution does not work, tune in another station. If this Message Appears Various messages are displayed on the screen during operation. In addition to the messages telling you the current status or providing guidance for the next operation, there are also the following error messages. If one of these error messages is displayed, carefully follow the instructions in the solution column. System Unable to operate while driving. • A setup operation, etc., was carried out while the vehicle was running. - Move the vehicle to a safe location, stop, and engage the parking brake, then carry out this operation. USB current error. • Abnormal current is run to the USB connector device. - Turn the ignition key off, and then set to ON again. - Attempt to connect another iPhone/Flash Memory device. Device no response. • There is no response for the connected Flash Memory device. - Attempt to connect another Flash Memory device. 28-EN