Alpine iLX-107 Owners Manual - Page 35

Radio Antenna Receptacle GPS Antenna Receptacle Connect to GPS antenna (Included). Speed Sensor Lead (Green/White) Improper connection of the speed pulse line may cause important safety features of the vehicle to fail (such as the brakes or air bags). Such failures may result in an accident and loss of life. We strongly recommend that the installation be performed by a trained, authorized Alpine dealer. CAMERA Input Connector iDataLink Interface Connector To iDataLink module. Video/Audio (R,L) Input Connector (AUX INPUT) Input the AUX Video/Audio (R,L). • When you use this connector, an optional AV/RCA interface cable should be used. Usable AV/RCA interface cable (4-pole mini AV plug to 3-RCA) Wiring convention of this system is as follows: Audio L (White) Audio R (Red) Ground Video (Yellow) Yellow Red White Video input terminal Audio input terminal (R,L) • Configuration commercially available 4-pole mini AV plugs is not standardized. Remote Turn-On Lead (Blue/White) Connect this lead to the remote turn-on lead of your amplifier or signal processor. Reverse Lead (Orange/White) Connect to the plus side of the car's reverse lights. These lights illuminate when the transmission is shifted into reverse (R). With this lead properly wired, the video picture automatically switches to the rear camera whenever the car is put into reverse (R). Power Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicable. • This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc. Parking Brake Lead (Yellow/Blue) Connect this lead to the power supply side of parking brake switch to transmit the parking brake status signals to the unit. Switched Power Lead (Ignition) (Red) Connect this lead to an open terminal on the vehicle's fuse box or another unused power source that provides (+) 12V only when the ignition is turned on or in the accessory position. Fuse Holder (15A) Battery Lead (Yellow) Connect this lead to the positive (+) post of the vehicle's battery. Ground Lead (Black) Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided. Left Rear (+) Speaker Output Lead (Green) Left Rear (-) Speaker Output Lead (Green/Black) Left Front (+) Speaker Output Lead (White) Left Front (-) Speaker Output Lead (White/Black) Right Front (-) Speaker Output Lead (Gray/Black) Right Front (+) Speaker Output Lead (Gray) Right Rear (-) Speaker Output Lead (Violet/Black) Right Rear (+) Speaker Output Lead (Violet) Steering Remote Control Interface Connector To steering remote control interface box. For details about connections, consult your nearest Alpine dealer. MIC Input Connector To microphone (Included) Front Output RCA Connectors Can be used as Front Output RCA Connectors. RED is right and WHITE is left. Rear Output RCA Connectors Can be used as Rear Output RCA Connectors. RED is right and WHITE is left. Subwoofer RCA Connectors RED is right and WHITE is left. CAN I/F Connector USB Connector To iphone 5 or later. Power Supply Connector W.REMOTE Connector PRE OUT Connector 35-EN