Asus T2-PE1 T2-PE1 English User Manual E2151 - Page 35
Connect one end of the optical drive audio cable to the 4-pin - cd
View all Asus T2-PE1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
6. Carefully push the optical drive into the bay until its screw holes align with the holes on the bay as shown. 7. Secure the optical drive with two screws on one side of the bay. 6 7 8. Connect a power cable from the power supply unit to the power connector at the back of the optical drive. See page 2-24 for 8 details. 9. Connect the IDE ribbon cable to the IDE interface at the back of 10 9 the optical drive, matching the red stripe on the cable with Pin 1 on the IDE interface. 10. Connect one end of the optical drive audio cable to the 4-pin connector at the back of the optical drive. 11. Make sure that the other end of the IDE ribbon cable is connected to the primary IDE connector (blue connector labeled PRI_IDE) on the motherboard. See page 4-6 for the location of the primary IDE connector. 12. Connect the other end of the audio cable to the 4-pin CD1 connector on the motherboard. See page 4-8 for the location of the CD audio connector. ASUS T2-PE1 2-17