Behringer K-2 Quick Start Guide - Page 21

40 K-2 K-2 Poly Chain ON LED System Mode LED ON LED Mode Amber Normal Mode Red Poly Chain Mode 1. Please use "SynthTool.exe" to configure the poly chain mode. 2. To enter or exit the poly chain mode, quickly press TRIG SW on the K-2 four times after powering up, while the ON LED is flashing. 3. The ON LED will light red during poly chain mode. TRIGGER SWITCH K-2 MIDI MIDI message Channel Message Status 8n 9n Bn En Examples Status Note on Note off All notes off Command(1) 90 3C 64 80 3C 40 B0 7B Note: (1) MIDI input channel 1. Second kk kk 7B bb Third Parameter Description vv [0, 7F] Note off vv [0, 7F] Note on - - All notes off bb [0, 3FFF] Pitch bend Specifications Synthesizer Architecture Number of voices Type Oscillators LFO VCF Envelopes Connectivity Power input Power switch MIDI In/Thru MIDI channel switch USB (MIDI) Outputs Outputs impedance Headphones Headphones output impedance USB Type Supported Operating Systems Controllers Section Controls Voltage Controlled Oscillators (VCO) Controls VCO Mixer Section Controls Voltage Controlled Filter Section Controls Switches Quick Start Guide 41 Monophonic Analog 2 (16 Hz to 1.5 kHz @ 8' and with 4 overlapping ranges) 1 (0.1 to 22 Hz) 1 low pass, 1 high pass (24 dB/octave slope) VCA, VCF DC input connector Push button On/Off MIDI In and MIDI Thru, 5-pin DIN Channel selection/ 16 channels USB 2.0, type B Output: 1/4" TS, unbalanced, max. 0 dBu Signal out: 3.5mm TS, unbalanced, max. 0 dBu 1.0 kΩ 3.5 mm TRS, max. +6 dBu 22 Ω Class compliant USB 2.0, type B Windows 7 or higher Mac OS X 10.6.8 or higher Master tune: -5 to +5 Portamento: 0 to 10 Range (VCO 1): 32', 16', 8', 4' Range (VCO 2): 16', 8', 4', 2' Pulse width (VCO 1): square to narrow Waveform (VCO 1): triangular, reverse sawtooth, pulse, noise Waveform (VCO 2): reverse sawtooth, square, narrow pulse, ring Pitch (VCO 2): -5 to +5 VCO 1 level: 0 to 10 VCO 2 level: 0 to 10 High pass cutoff frequency: 0 to 10 (10 Hz to 20 kHz) Low pass cutoff frequency: 0 to 10 (10 Hz to 20 kHz) High pass peak (resonance): 0 to 10 Low pass peak (resonance): 0 to 10 Filter selector: filter 1/filter 2