Beko BDVG693 User Manual - Page 18

4. Check all connections for secure fitting and tightness. i n] New injectors have their position marked on their packing or injector table on Injector table, page 7 can be referred to. 2 3 4 Flame failure device 2 Sparking plug 3 Injector 4 Burner Unless there is an abnormal condition, do not attempt to remove the gas burner taps. You must call an Authorised service agent if it is necessary to change the taps. Reduced gas flow rate setting for hob taps clockwise. If it is smaller turn anticlockwise. 5. For the last control, bring the burner both to high-flame and reduced positions and check whether the flame is on or off. Depending on the type of gas tap used in your appliance the adjustment screw position may vary. 00 OO 1 V Flow rate adjustment screw *0 OO 1. Ignite the burner that is to be adjusted and turn the knob to the reduced position. 2. Remove the knob from the gas tap. 3. Use an appropriately sized screwdriver to adjust the flow rate adjustment screw. For LPG (Butane - Propane) turn the screw clockwise. For the natural gas, you should turn the screw counter-clockwise once. » The normal length of a straight flame in the reduced position should be 6-7 mm. 4. If the flame is higher than the desired position, turn the screw 171EN Flow rate adjustment screw