Bernina 2500DCET Manual - Page 33

2500_DCE_1_englisch_neu 09.10.2007 14:35 Uhr Seite 34 Overlock threading Needle L (yellow markings) 1 2 Place the spool on the spool pin as illustrated. 34 2 3 5 6 4 7 8 1. Bring the thread up from the spool and lay it from the back to the front into the guide. 2. Thread the first thread guide. 3. Slip the thread through the groove. 4., 5., 6. Take the thread under the thread guide plate, through the take up and into the guide. 7. Thread guide on the needle clamp. 8. Thread needle L from front to back and lay the thread to the left under the foot. After threading 8 When threading is complete, lower upper knife (if raised), close the looper cover (place waste collector in position). Re-threading or changing threads If spools are empty or you want to change the thread, it is not necessary to re-thread the machine. Simply cut off the threads above the cones or spools, replace them and knot new thread on to the existing thread. Cut the threads off at the needles. Raise the presser foot, pull the threads through and re-thread the needles. Pull the looper threads through using the existing thread chain. Some thick decorative threads cannot be pulled through the looper eyes. Lower the presser foot. Select the stitch of your choice and test sew.